If you have installed a hot water system in your home, it is important that it should be serviced and repaired by fully qualified professional. Having a regular maintenance will not only extend the life of your hot water fixtures but also allows you to save money and time.
In Australia, hot water is a necessity and a way to take advantage of the abundant supply of sun and water for every household. Moreover, there are available solar panel systems to save energy and therefore reduce the water heating expenditures. Solar based water heater can provide outstanding benefits and can supply for up to 50-90% of a household needs.
Replacement And Installation
Hot water system requires periodic maintenance and most of the time, it is being disregarded and used without appropriate maintenance that causes corrosion and rust until the problem comes in.
Water leakage is one of the major problems of hot water system. If this occurs, immediate replacement must be required. Water heaters usually last for 15 years. You can choose between gas hot water system and electric water system and make sure to check its gallon capacity, recovery rate, dimension and energy efficiency.
Here are some important guidelines in case problem occurs:
• Check if the power is properly attached. Reset the thermostat.
• Remove tank sediments by flushing the heater
• Replace the heating elements
• Insulate pipes
• Check gas connection and pilot light
• Increase temperature setting on thermostat
• Clean and replace burner and thermocoupler
Hire A Professional
Hiring a professional plumber to manage your heating system is very crucial to ensure the safety and accuracy of installation. But if you choose to do it on your own, make sure you are fully aware with the plumbing codes as well as the necessary requirements involving it. Might as well research or ask your local plumbing inspector.
What Hot Water Professional Do?
1. Delivery and unpacking of your hot water system.
2. Check damage and defects
3. Provide the best recommendations and estimate
4. Ensure that installation is code-approved
5. Ensure level and safety of installation with manufacturer-supplied safety hardware.
6. Conduct testing on water heating system and treatment to ensure its performance.
7. Provide clients with easy to understand instructions and information.
8. Provide warranty and back up
9. Cleaning and maintenance service
If you need more information about hot water system and installation in Australia, you may contact Hotwater Perth Company. Rest assured, their service comes with a comprehensive warranty, quality and accuracy.
